UT-130 USB DVB-T 4-band (100~2600MHz, 2~8MHz BW) Receiver

Description

UT-130 - Features
USB based demodulator with support for EN 300-744 DVB-T reception.
No extra down converter needed, direct support for wide frequency range reception, including standard TV VHF/UHF (100MHz~950MHz) band, 1.2GHz band, and 2.4GHz band*.
Flexible channel bandwidth support, 2/3/4/5/6/7/8 MHz
*Basically, full range (100MHz~2600MHz) is supported, except the pre-AMP LNA (MAX2644/MAX2691) performance may degrade in some bands.
Host Requirements
CPU: Intel, AMD, ARM, MIPS
128MB RAM of system memory or above
Higher CPU and memory required if DVB-T audio/video decoding is needed
One available USB2.0 or 1.1 port
Note: USB 1.1 can only support 3~5 Mbps stream data rate.
Parameter
Value
RF connector
Three 50-Ω SMA (female) connecters, for
1.
standard TV band 100MHz~950 MHz
2.
Lower band (<1900MHz, 1.2G band)
3.
Upper band (>=1900MHz, 2.4G band)
(IPEX on-board)
Bandwidth
2/3/4/5/6/7/8 MHz
FFT
2K, 4K, 8K
Constellation
64QAM/16QAM/QPSK
Code rate
1/2, 2/3, 3/4, 5/6, 7/8
Guard interval
1/4, 1/8, 1/16 or 1/32
Frequency range
100~950MHz
Lower band: 1100~1350MHz* (<1900MHz)
Upper band: 2200~2600MHz* (>=1900MHz)
RF-in Pmax
-10 dBm
(Recommended 2.4GHz < -15 dBm, 1.2GHz < -25 dBm)
USB port
USB 2.0 or USB 1.1
Power
5V DC, USB bus power
177MHz: 460mA
666MHz: 480mA
1.2G:
500mA
2.4G:
470mA
Dimensions
Bare bone
82x 35mm
Box
W(105 mm) x D(75 mm) x H(35 mm)
*Note:
The frequency range is only for reference and not limited. Basically full range (100MHz ~2.6GHz) is supported, but the pre-AMP LNA’s performance will be degraded in the band out of the range specified.
The frequency range is specified based on >10dB gain for the pre-AMP LNA.
Refer to the specifications of the pre-AMP LNA Maxim MAX2644 /
MAX2691 for further details.